How to reset NVRsolo to factory default?
How to reset NVRsolo factory default setting?
1. Verify that the system is fully booted.
2. Insert your reset tool into the reset button hole on the back of the device. 
3. Press and hold the reset button for 14 seconds, release your hands until the buzzer beeps twice and the System Status LED flashes in orange.
4. System will restart and all settings are reset to default.

Note: As you reset, it will take you some time, please be patient until you hear the buzzer beeps twice. 
5. If the above instructions doesn't work, please contact us at eHelpdesk.

Customer Feedback
Please rate this article
Somewhat helpful
Not helpful
Not applicable



Channel Partners

  © Copyright 2021 NUUO Inc. All Rights Reserved.   │Contact UsSite MapPrivacy Statement