[Crystal] Alien Volume
Symptom
When going to the setting tab in NuClient, it pop up message below saying the system detects an alien volume


Cause
That volume is from another Crystal and the current Crystal doesn't recognize this volume

Solution
By choosing ''Repair'' the NVR shall start the repairing process which may take couple hours

If it doesn't give you the option ''Repair'', means there are some recording sequence number conflic between Volume. Please move all volume back to ''Available Disk Group Area'' and leave only the Volume you want to repair.

Please note that we don't recommend to combine the Volume of two different Crystal into one since there will be always recording sequence conflic. Once backup the desired footage, we recommend that you can format the alien volume to avoid recording sequence conflict
 
Customer Feedback
 
Please rate this article
Helpful
Somewhat helpful
Not helpful
Not applicable
 
 
 

NuCalculator



eHelpdesk



Channel Partners



  © Copyright 2016 NUUO Inc. All Rights Reserved.     │Contact UsSite MapPrivacy Statement