Why the NVR’s system time is changed after rebooting NVR?
Symptom
The system time of NVR has been changed to the incorrect time after NVR shutting down cause by electrical outage.

Cause
It is probably caused by that the battery is running low power.
 
Solution
Please follow below steps to do the further tests of this issue.
1. Sync the system time to correct time manually.
2. Power off Titan NVR.
3. Plug out the power cord and wait 30 seconds.
4. Plug in the power cord and power on Titan.
 
If the issue still remains after done those above instructions, it might need to send back to NUUO to do further check. Please apply a ticket on eHelpdesk and we will help you to launch RMA procedure.

 
Customer Feedback
 
Please rate this article
Helpful
Somewhat helpful
Not helpful
Not applicable
 
 
 

NuCalculator



eHelpdesk



Channel Partners



  © Copyright 2016 NUUO Inc. All Rights Reserved.     │Contact UsSite MapPrivacy Statement